H3C WX3000 Installation Manual page 38

Figure 3-18 Screw
Figure 3-19 Wall anchor
(1) Outside edge of wall anchor
Installation procedure
Follow these steps to mount the device on the wall:
Step1 As shown in Figure 3-20, drill two holes with a diameter of 5 mm (0.2 in.) across in the wall on the same
horizontal line, with a distance of 170 mm (6.69 in.).
Drill two holes according to the sizes of wall anchors and screws so that wall anchors could go into the
holes, only the edges could remain outside the wall, and the screws could be fixed on the wall tightly.
Step2 Insert wall anchors into the holes and keep only the edges outside the wall.
Step3 Drive screws into the wall anchors, keeping the inside of screw head at least 1.5 mm (0.06 in) away
from the edge of the wall anchor so that the device could hang on the screws securely.
(1) (1)
3-12