Wiring Connection - JVC KD-R671 Instruction Manual

Wiring connection

IMPORTANT
We recommend installing the unit with
a commercially available custom wiring
harness specific for your car and leave
this job to professionals for your safety.
Consult your car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
(separately purchased)
Blue: To power antenna
Blue/white: To amplifier
* 2
You can also connect
a subwoofer speaker
directly using this
lead without an
external subwoofer
amplifier. For setting,
11, 12.
Recommended connection
18 18
KD-R671 KD-R571 / KD-R476 /
KD-R471
Front output
Rear/subwoofer
output
Antenna terminal
To the steering
Light blue/yellow
wheel remote
STEERING
control adapter
WHEEL
REMOTE
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
Brown: Tel muting
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker (right)
Gray/black
White: Front speaker (left)
White/black
Purple: Rear speaker (right)
Purple/black
Green: Rear speaker (left) *
Green/black *
Signal cord
(not supplied)
Rear/
subwoofer
output
Fuse (10 A)
Ignition switch
Separate red wire
Make this connection if your
vehicle factory wiring harness
does not have "12 V ignition
switch" wire.
2
2
* 1
Firmly connect the ground
wire of the amplifier to
the car's chassis to avoid
JVC Amplifier * 1
damaging the unit.
Part list for
installation
Remote wire
(not supplied)
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
Car fuse block
(D) Wiring harness
(E) Extraction key