Wiring Connection - JVC KD-R690S Instruction Manual

INSTALLATION/CONNECTION

Wiring connection

IMPORTANT
We recommend installing the unit with a commercially
available custom wiring harness specific for your car
and leave this job to professionals for your safety.
Consult your car audio dealer.
Vehicle dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
(separately purchased)
Brown (not used)
Recommended connection
24
ENGLISH
KD-R690S/KD-R492
Output
terminals
To the steering wheel
remote control adapter
Join the same color wires together.
Blue: To power antenna
Blue/white: To amplifier
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker (right)
Gray/black
White: Front speaker (left)
White/black
Purple: Rear speaker (right)
Purple/black
Green: Rear speaker (left) *
Green/black *
KD-R490
Antenna terminal
Fuse (10 A)
Light blue/yellow
Blue/white: Remote (12 V 350 mA)
2
2
Signal cord (not supplied)
KD-R690S: Expansion port (12 V
To the optional SiriusXM Vehicle Tuner
(commercially available) ( 11)
Ignition switch
Separate red wire
Car fuse block
Make this connection if your vehicle factory wiring harness
does not have "12 V ignition switch" wire.
Firmly connect the ground wire of the amplifier to the
* 1
car's chassis to avoid damaging the unit.
You can also connect a subwoofer speaker directly using
* 2
this lead without an external subwoofer amplifier. For
setting,
16.
JVC Amplifier *
1
500 mA)
Remote wire
(not supplied)