Wiring Connection - JVC KD-DB53 Instruction Manual

Wiring connection

To the steering wheel remote control adapter
For some VW/Audi or Opel (Vauxhall)
automobiles
You may need to modify the wiring of the supplied
wiring harness D as illustrated.
If the unit does not turn on with modified wiring 1,
use modified wiring 2 instead.
Y: Yellow R: Red
Original wiring
Modified wiring 1
( or )
Modified wiring 2
Signal cord
(not supplied)
Rear/subwoofer output
Aerial input (for FM/AM)
DAB aerial terminal
(SMB connector)
Light blue/yellow
STEERING
WHEEL
REMOTE
If your car has an ISO terminal
( or )
If your car does NOT have an ISO terminal
* Custom wiring harness (separately purchased)
IMPORTANT: A custom wiring harness (separately
purchased) which is suitable for your car is
recommended for connection.
Remote wire
To Blue/white wire of
(not supplied)
the wiring harness D
(When using a remote wire having
JVC Amplifier
ISO connectors, connect the ISO
connectors to the corresponding
Fuse (10 A)
sockets.)
Purple ª / Purple/black ·:
B1/B2
Rear speaker (right)
Gray ª / Gray/black ·:
B3/B4
Front speaker (right)
White ª / White/black ·:
B5/B6
Front speaker (left)
Green ª / Green/black ·:
B7/B8
Rear speaker (left)
A2 Brown: Tel muting
A4 Yellow: Battery
A5 Blue/white: Remote wire
Orange/white: Car light control
A6
switch
A7 Red: Ignition (ACC)
Black: Earth (ground)
A8
connection
• When using a cable that does not have
ISO connectors, cut the cable. Insulate
the cut cable by putting tape on the
cable conductor. Short circuit can
damage the vehicle.
15
Part list for installation
A Faceplate
B Mounting sleeve
ISO connector
C Trim plate
D Wiring harness
E Extraction key
( ×1 )
( ×1 )
( ×1 )
( ×1 )
( ×2 )
ENGLISH