Wiring Connection - JVC KD-R482 Instruction Manual

INSTALLATION/CONNECTION

Wiring connection

IMPORTANT
We recommend installing the unit with a commercially available custom
wiring harness specific for your car and leave this job to professionals for
your safety. Consult your car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness Blue:
(separately purchased) To power antenna
Blue/white:
To amplifier
Brown (not used)
Recommended connection
16
ENGLISH
Antenna terminal
Light blue/yellow
To the steering wheel
remote control adapter
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker (right)
Gray/black
White: Front speaker (left)
White/black
Purple: Rear speaker (right)
Purple/black
Green: Rear speaker (left) *
Green/black * 2
Rear/subwoofer output
Separate red wire
Make this connection if your vehicle factory wiring
harness does not have "12 V ignition switch" wire.
* 1
Firmly connect the ground wire of the amplifier to the
car's chassis to avoid damaging the unit.
* 2
You can also connect a subwoofer speaker directly using
2
this lead without an external subwoofer amplifier. For
setting,
Signal cord (not supplied)
JVC Amplifier *
Fuse (10 A)
Remote wire
(not supplied)
Ignition switch
Car fuse block
10.
1