Wiring Connection - JVC KD-X200 Instruction Manual

Wiring connection

JVC Amplifier
Remote
1
wire*
Ignition switch
Fuse block
Separate
red wire
Make this
connection if your
vehicle factory
wiring harness does
not have "12 V
ignition switch" wire.
Vehicle-specific Wiring Harness
(separately purchased)
*1 Not supplied for this unit.
1
Signal cord*
10 A fuse
Antenna terminal
Light blue/yellow
KD-X200
Join the same color wires
together.
Blue: Automatic antenna
(250 mA max.)
Blue/white:
Remote (200 mA max.)
Orange/white: Illumination
Brown: Tel muting
Yellow: 12 V Battery
Red: 12 V Ignition switch
Black: Ground
White: Front speaker (left)
White/black
Gray: Front speaker (right)
Green: Rear speaker (left)
Green/black
Purple: Rear speaker (right)
Purple/black
KD-X150
Rear/subwoofer output
Rear ground terminal
Factory wiring
harness (vehicle)
To the steering wheel
remote control adapter
Recommended
connection
Blue: To power antenna
Blue/white: To amplifier
Gray/black
For more information:
Metra Electronics:
Scosche Industries:
Installation/Connection
www.metraonline.com
www.scosche.com
ENGLISH | 19