Preparing Milk Froth And Warm Milk - Bosch TES?803 Instruction Manual

Hide thumbs Also See for TES?803:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
16
Drink preparation with milk
The appliance must be ready for use.
● Place the suction pipe 10d of the milk
frother 10 deep in the milk container 26.
● Swivel the coffee outlet 9 to the right until
it clicks into place.
● Place the pre-warmed cup or glass under
the coffee outlet 9 and milk frother 10.
● Select the required
TES807),
Macchiato
Ç
or
My coffee
ing the rotary knob 6.
● Open the powder compartment 18.
● Pour in no more than 2 level measuring
spoons 14 of ground coffee.
¡ Warning!
Do not use whole beans or instant coffee.
● Close the powder compartment 18.
● Press the start button 8.
First milk is delivered into the cup or glass.
Then the coffee is brewed and dispensed
into the cup or glass.
Important: Dried milk residue is difficult
to remove, so the milk frother 10 must be
cleaned with lukewarm water immediately
after use (see "Cleaning the milk system").
Note: Repeat the procedure for another
cup of coffee / milk drink. If coffee is not
dispensed within 90 seconds, the brewing
chamber empties automatically to avoid an
overflow. The appliance rinses.
Robert Bosch Hausgeräte GmbH
TES803_805_807_1RW.indb 16
Ä
Caffe Latte
(only
,
Cappuccino
Å
Æ
(only TES807) by turn-
Preparing milk froth and
warm milk
¡ Risk of burns!
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
● Place the suction pipe 10d of the milk
frother 10 deep in the milk container 26.
● Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
● Select the required setting
or
by turning the rotary
Warm milk
É
knob 6.
● Press the start button 8.
Milk froth or warm milk flows from the outlet
of the milk frother 10.
Press the start button 8 again to cut the
process short.
Info: When preparing warm milk, you may
hear a whistling sound. This is caused by
the milk frother 10 for technical reasons.
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important: Dried milk residue is difficult
to remove, so the milk frother 10 must be
cleaned with lukewarm water immediately
after use (see "Cleaning the milk system").
en
Milk froth
È
08.05.2013 14:52:59

Advertisement

Table of Contents
loading

This manual is also suitable for:

?tes?805?tes?807

Table of Contents