Preparing Milk Froth And Warm Milk; Dispensing Tea Water - Bosch TCC78K751 Operating Instructions Manual

Preparing milk froth
and warm milk
Risk of burns!
The milk frother (12) gets very
hot. After use, allow to cool
down first before touching.
For optimal milk froth quality, use
cold milk with a fat content of at
least 1.5 % if possible.
1. Take the milk tube and connect it to
the milk frother (see "Preparation
using milk").
2. Place a cup or glass under the outlet of
the milk frother (12).
3. Select the required Milk froth or Warm
milk setting by turning the rotary knob
(5):
4. Press o start/stop (10).
Milk froth or warm milk runs out of the
milk frother outlet (takes about 40 or 60
seconds respectively).
Press o start/stop (10) again to cut the
process short.
The appliance may make a
whistling noise when warm milk is
being prepared. This is caused by
the milk frother (12) for technical
reasons.
Dried milk residue is difficult
to remove, so clean the milk
frother immediately after use
(see "Cleaning the milk system").
Bosch

Dispensing tea water

Risk of burns!
The milk frother (12), from which
the tea water flows, gets very
hot. After use, allow to cool down first
before touching.
The appliance can also be used to prepare
tea.
1. Place a cup or glass under the coffee
outlet.
2. Select Tea water with the rotary knob
(5):
3. Press X (4) to switch to the
temperature selection. Set the required
temperature with the rotary knob
4. Press o start/stop (10).
Hot water runs out of the milk frother
outlet for about 40 seconds.
Press o start/stop (10) again to cut the
process short.
Warm up cups before use,
especially small, thick espresso
cups, with the hot water.
English | 47
(5):
TCC78K751 | 01/2014