Montigo H34DF Installation Operation & Maintenance page 17

H38DF H42DF
Align
Air Inlets
Bottom Left Log
Figure 30b. Placing Bottom Left Log.
Step 3. Place the bottom Left log as shown in figure 30b.
Figure 30c. Placing Bottom Right Log.
Step 4. Place the bottom Right log as shown in figure 30c.
Top
Left Log
Align Pins
Top Left
Log
Figure 30d. Placing Top Right and Left Logs.
Step 5. Place the Top Right and Left logs using the (4) four alignment
pins protruding from the top of the Right and Left Bottom Logs,
as shown in figure 30d. With these pins align the Top Right and
Left logs using the predetermined alignment holes cast into the
underside of the logs, as shown above, figure 30d insets.
Part No. XG0145
Installation
Align
Bottom Right Log
Right Log
Align Pins
Notch in Log
Top Right
Step 6. Place the Centre Front log , Figure 30e below, as shown using the
notch cast in the Bottom Rear log as shown in figure 30d above.
Figure 30e. Placing Centre Front Log.
Step 7. Place the Front Centre log as shown in figure 30e.
Figure 30f. Placing Right Front Log.
Step 8. Place the Right Front log as shown using the notch in the Top
Top
Right log as a guide, figure 30f.
Log
Figure 30g. Placing Embers.
Step 9. Place the Embers as shown in figure 30g.
Arrange the ember chips on top of the burner tray. Care should be taken
when placing the embers, as blocked burner ports may cause an
incorrect flame pattern, carbon deposits and delayed ignition. Also,
the embers must never be placed in a way that obstructs any of
the air inlet ports, located at the rear of the burner, as shown in
figure 30b.
If logs are not placed properly, excessive sooting
■
will result.
The surface of the logs will crack due to the heat from
■
the flames. This is a normal occurrence.
H-Series DF Gas Fireplace
Center Front Log
Centerline of Fireplace
Right Front
Log
Rest Log
Place Embers in this area
Cautions:
Groove
in Log
Page 17