Remove The Insulating Strip From The Remote Control; Battery Installation For The Remote Control; Handling The Battery - Sandstrom SHFUSB10 Instruction Manual

Remove the Insulating Strip from the Remote Control

Remove the insulating mylar strip from the battery if the battery is
being used for the first time. It is located at the bottom back side of
the remote control.

Battery Installation for the Remote Control

1. Unwind the screw and slide open the battery
compartment of the remote control.
2. Remove the old battery, and place a new
battery (CR2025 Lithium Battery) in the holder.
3. Close the battery compartment cover and
wind the screw back on.

Handling the Battery

• Improper or incorrect use of batteries may cause corrosion or battery leakage, which
could cause fire, personal injury or damage to property.
• Install the battery correctly by following the polarity (+ and -) indications in the battery
compartment.
• When the battery is exhausted, the remote control will not function.
• Only use the battery type indicated in this manual.
• Do not dispose of the used battery as domestic waste. Dispose of it in accordance with
local regulations.
• Small button cell batteries such as the one used in the remote control are easily
swallowed by young children and this is dangerous. Keep loose button cells away from
young children and make sure that the battery holder tray is secure in the remote
control. Seek medical advice if you believe a cell has been swallowed.
GB-9