Remove The Insulating Strip From The Remote Control; Battery Replacement For The Remote Control - Sandstrom Lifestyle DAB HiFi Instruction Manual

Remove the Insulating Strip from the Remote Control

Remove the insulating mylar strip from the battery
if the battery is being used for the first time. It is
located at the bottom back side of the remote
control.

Battery Replacement for the Remote Control

The remote control requires a CR2032, 3V Lithium battery.
1. Slide and hold the battery release tab in the
direction of the arrow.
2. Pull out the battery holder and remove the old
battery.
3. Replace with a new one battery.
4. Insert the battery holder back into the remote
control.
Handling the Battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which
could cause fire, personal injury or damage to property.
• Install the battery correctly by following the polarity (+ and –) indications in the battery
compartment.
• When the battery is exhausted, the remote control will not function.
• Only use the battery type indicated in this manual.
• Do not dispose of the used battery as domestic waste. Dispose of it in accordance with
the local regulations.
• Small button cell batteries such as the one used in the remote control are easily
swallowed by young children and this is dangerous. Keep loose button cells away from
young children and make sure that the battery holder tray is secure in the remote
control. Seek medical advice if you believe a cell has been swallowed.
11