Flexiblelom Riser Cage Assembly - HP hpe proliant dl20 gen9 User Manual

Install the DIMM.
8.
Install the air baffle (on page 24).
9.
Install the access panel (on page 21).
10.
Do one of the following:
11.
Slide the server into the rack.
o
Install the server into the rack
o
Connect each power cord to the server.
12.
Connect each power cord to the power source.
13.
Power up the server (on page 17).
14.
If removed, install the security bezel
15.
After installing the DIMMs, use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities
UEFI System

FlexibleLOM riser cage assembly

For more information on the riser board slot specifications, see "PCIe riser board slot definitions (on page
10)."
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To install the component:
If installed, remove the security bezel (on page 17).
1.
Power down the server (on page 17).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
Extend the server from the rack (on page 18).
o
Remove the server from the rack (on page 19).
o
Remove the access panel (on page 20).
5.
Remove the existing PCI riser cage
6.
Utilities" on page 98) to configure the memory protection mode.
("Installing the server into the
("Security bezel option" on page 36).
("Remove the PCI riser
rack" on page 30).
cage" on page 22).
Hardware options installation 67
("HPE