Husqvarna 105 Operator's Manual page 22

It is possible to let the low voltage cable cross the
working area. The low voltage cable must be stapled
down or buried, and the cutting height should be such
that the blades on the blade disc can never come in
contact with the low voltage cable.
Make sure the low voltage cable is laid along the
ground and secured with pegs. The cable must lie
close to the ground so as not to be cut before the
grass roots have grown over it.
The low voltage cable must never be stored in a coil
or under the charging station's base plate as this can
interfere with the signals from the charging station.
The power supply must be placed where it is well
ventilated and is not exposed to direct sunlight. The
power supply must be placed under a roof.
It is recommended to use an earth fault-breaker when
connecting the power supply to the wall socket.
Do not, under any circumstances, mount the power
supply at a height where there is a risk it can be
submerged in water (at least 30 cm from the ground).
It is not permitted to place the power supply on the
ground.
Never connect the power supply to an outlet if plug or
cord is damaged. Damaged or entangled cord
increases the risk of electric shock.
IMPORTANT INFORMATION
The low voltage cable must not under any
circumstances be shortened or extended.
IMPORTANT INFORMATION
Place the low voltage cable so that the blades
on the blade disc can never come in contact
with it.
IMPORTANT INFORMATION
Use the plug to disconnect the charging
station, for instance before cleaning or
repairing the loop wire.
22 - English
3. INSTALLATION
min 30cm/12"
3018-085
3012-281
3012-1344