Security - Husqvarna 105 Operator's Manual

Drive past wire
The front of the mower always passes the boundary
wire by a specific distance before the mower turns.
The default distance is 25 cm, but this can be
changed if required. The minimum value is 25 cm and
the maximum value is 30 cm. Note that the distance
given is only an approximate value and should be
regarded as a guide. In reality, the actual distance the
robotic mower passes the boundary wire can vary.
Now specify the number of centimetres you want the
mower to pass the boundary wire and press OK.

6.5 Security

Through this selection, settings relating to security
and the connection between the mower and the
charging station can be made.
Change PIN code
Enter the new PIN code and press OK. Enter the
same code again and confirm by pressing OK. When
the PIN code is changed, a message stating that the
PIN code has been changed appears in the display
momentarily.
Make a note of the new PIN code on the designated
line in Memo on page 4.
Security level
There are three security levels to choose from: low,
medium and high Low and medium security prohibits
access to the robotic lawnmower if the PIN code is
unknown. High security also includes a warning that
beeps if the correct PIN code is not entered after a
designated time period.
To disable the robotic lawnmower, press down the
stop button and set the main switch to 0.
Function
Time lock
PIN request
Alarm
52 - English
6. MENU FUNCTIONS
Low Medium
X X
X
Guide width
Remote start 1
Remote start 2
Test settings
Drive past wire
Timer
Installation
Security
Settings
Change PIN code
Security level
New loop signal
High
X
X
X
Change PIN code
Security level
New loop signal
Low
Medium
High