Symptoms - Husqvarna 105 Operator's Manual

9.3 Symptoms

If your Automower does not work as expected, follow the troubleshooting guide below.
®
There is a FAQ (Frequently Asked Questions) on www.automower.com which provides more detailed answers
to a number of standard questions. It you still cannot find the reason for the fault, contact the local dealer.
Symptoms
The robotic lawn
mower has difficulty
docking with the
charging station
Uneven mowing
results
The robotic
lawnmower runs at
the wrong time
72 - English
9. TROUBLESHOOTING
Cause
The boundary wire is not laid in a long
straight line that is far enough out
from the charging station.
The guide wire is not inserted in the
slot at the bottom of the charging
station.
The charging station is on a slope
The robotic lawnmower works too few
hours per day.
The proportion setting is incorrect in
relation to the layout of the working
area
The shape of the working area
requires the use of both Remote start
1 and Remote start 2 for the robotic
lawnmower to find its way to all
remote areas.
Working area too large.
Dull blades.
Long grass in relation to the set
cutting height.
Accumulation of grass by the blade
disc or around the motor shaft.
The robotic lawnmower clock needs
to be set.
The start and stop times for mowing
are incorrect.
Action
Check that the charging station has
been installed according to the
instructions in 3.2 Installation of the
charging station on page 19.
It is absolutely critical for operation
that the guide wire is perfectly straight
and is in the correct position under
the charging station. Therefore make
sure that the guide wire is always in
its slot in the charging station. See
3.6 Installation of the guide wire.
Place the charging station on a
surface that is entirely level. See
3.2 Installation of the charging station
on page 19.
Increase the mowing time. See
6.3 Timer on page46.
Check that the correct Proportion
value is selected. See 6.4 Installation
on page 48.
Also use Remote start 2 to steer the
robotic lawnmower to a remote area.
See 6.4 Installation on page 48.
Try limiting the working area or
extending the working time. See
6.3 Timer on page 46.
Replace all the blades and screws so
that the rotating parts are balanced.
See 8.7 Blades on page 64.
Increase the cutting height and then
successively lower.
Check that the blade disc rotates
freely and easily. If not, screw off the
blade disc and remove grass and
foreign objects. See 8.4 Cleaning.
Set the clock. See 6.6 Settings on
page 54.
Reset the start time and stop time
settings for mowing. See 6.3 Timer
on page 46.