Husqvarna 105 Operator's Manual page 21

If the installation is done in a working area with a
steep slope (such as around a house on a hill), the
charging station should be placed in the area at the
bottom of the slope. This makes it easier for the
robotic lawnmower to follow the guide wire to the
charging station.
The charging station should not be placed on an
island as this limits the laying of the guide wire in an
optimal way. If the charging station has to be installed
on an island, the guide wire also has to be connected
to the island. See the illustration. Read more about
islands in the 3.4 Installation of the boundary wire
chapter.
Connecting the power supply
Take the following into consideration when planning
where to place the power supply:
• Close to the charging station
• Protection from rain
• Protection from direct sunlight
If the power supply is connected to an electrical
socket outdoors, this must be approved for outdoor
use.
The low voltage cable for the power supply is
10 metres long, and may not be shortened or
extended. A longer low voltage cable is available as
optional accessory. Please contact your dealer for
more information. It is not allowed to connect the
power supply directly to the charging station. The low
voltage cable must always be used.
IMPORTANT INFORMATION
The low voltage cable must not under any
circumstances be shortened or extended.
3. INSTALLATION
3018-059
3018-068
3012-1352
3018-069
English - 21