How To Set-Up - Hipod JS7A/2010 Instructions For Installation & Use

hoW to Set-UP

bAbY USe reArWArd FACINg
ADJUSTINg HARNESS STRAP HEIgHT: FOR BABy USE REARwARD-FACINg
Correct fitment of the harness is very
important as it restrains the baby in the
restraint. the harness must fit firmly
around upper torso of the baby and be
Shoulder
positioned so as to leave the baby's arms
height
and legs free.
markers
For babies in rear facing mode, the infants
shoulders must be below the lower
Padded Insert
shoulder height marker. If your baby has
(if supplied)
reached the lower shoulder height marker
then the restraint must be converted for
lap straps
"Child Use". (refer to Forward Facing
section starting on page 26).
the shoulder straps must be in the slots
which are nearest to the child's shoulders,
but not lower than the child's shoulders
when in rear facing mode.
Cross
bar
REARwARD-FACINg
BELT PATH
;
shown as blue.
12
Harness
Shoulder slots
Harness
shoulder
straps
Harness
tongues and
buckle
Crotch straps
Adjustment
lever
Harness
adjuster strap
Cross bar
IMPORTANT:
Shoulder straps
MUST be threaded
through appropriate
shoulder strap slots
then over the cross
bar at the rear of
restraint.
Strap Connector
CHANgINg SHOULDER STRAP SLOTS: FOR BABy USE REARwARD-FACINg
A. If fitted in the car, remove the restraint from vehicle
as instructed on page 25.
b. to slacken harness Straps, lift harness Adjustment
lever then grasp both shoulder harness straps and
pull outwards.
C. If using the seat for the first time, you may need to
use the second set of shoulder strap slots rather than
the lowest pair of slots. Place baby in the seat and
check which shoulder strap slots are best.
d. At the rear of the restraint, remove one of the
harness shoulder straps from metal Strap Connector
by slipping strap through open slot. It is better to
change one strap at a time.
hoW to Set-UP
bAbY USe reArWArd FACINg
Pull to
lengthen
Lift Harness
Adjustment Lever
Cross bar
Strap
Connector
D
13