Table of Contents
Advertisement
hoW to INStAll
bAbY USe reArWArd FACINg
g. engage seat belt buckle and tongue.
h. re-attach the cover by connecting the plastic
fasteners and align restraint centrally to the
chosen seating position.
I. tighten the seatbelt. If installed with a lap-sash
seat belt tighten both the lap and sash belts,
then allow the sash-belt to feed into the
retractor.
J. hook the attachment clip to the car's anchor fitting.
remove as many twists as possible from the upper
anchorage strap. (this may be done after the baby is
fitted in to the seat).
thIS tether StrAP mUSt AlWAYS be FItted WheN
the ChIld reStrAINt IS USed IN A VehICle.
k. tighten adjustable upper anchorage
strap by pulling adjustment strap (3) to
remove slack, but do not over-tighten
causing the restraint base to lift off the
vehicle seat. this will usually be done
once the baby has been harnessed into
the seat.
ALwAyS roll up excess strap tightly
and neatly store away from child's
reach using the storage band.
18
Attachment Clip (hook)
Car's Anchor
Fitting
Fully press Adjuster button (1)
while pulling Upper Anchorage
Strap (1) to lengthen.
1
2
Storage
roll up tightly so
band
3
the webbing is thick
enough to be held in
Pull Adjustment Strap
the storage band.
to remove slack
g
A single
twist is
required in
baby Use.
do not use
this slot for
baby Use
installation.
DO NOT USE RESTRAINT IN REARwARD FACINg MODE wITHOUT STABILISINg BAR
FULLy EXTENDED.
THE UPPER ANCHORAgE STRAP MUST ALwAyS BE FITTED wHEN THE CHILD RESTRAINT
IS USED IN A VEHICLE.
ALwAyS ATTACH THE HOOK AND REMOVE THE SLACK.
hoW to INStAll
bAbY USe reArWArd FACINg
Attachment Clip (hook)
ensure Upper Anchorage
Strap is not slack,
attached to the car's
Anchor Fitting.
Feed seat belt between
restraint cover and restraint
body (see page 17).
blue marker to identify
Pull strap
REARwARD FACINg SEAT
to remove
BELT PATH.
the slack.
Car's Anchor Fitting
Pull sash portion
of seat belt to
remove slack.
19
Hide quick links:
Advertisement
Table of Contents
