Table of Contents
Advertisement
hoW to USe
bAbY USe reArWArd FACINg
h. Pull harness adjustment strap to take up the slack in the
harness adjusting to a comfortable but firm fit. A loose
harness could result in serious injury in a crash.
CAUTION: A LOOSE HARNESS IS DANgEROUS.
make sure that nothing is obstructing harness straps and that
baby's arms and legs are free with the straps in the correct
location - as shown on the previous page. do not use restraint
if straps do not tighten and contact Customer Service for repair
(telephone number at the back of this book).
IMPORTANT PADDED INSERT :
A recommended Padded Insert can be used to snugly support a
baby. do not use a baby insert pad that is not recommended for this child restraint by Next generation Nursery
Products. discontinue use when baby Insert Pad is a tight fit or creates discomfort for larger babies or causes
the baby's shoulder to reach the lower Shoulder height marker.
I. retighten Adjustable Upper Anchorage Strap by
pulling Adjustment Strap (3) to remove slack
as shown.
ALwAyS roll up excess strap tightly and neatly
store away from child's reach using the storage
band.
24
Pull
Press
1
Storage
band
3
Pull Adjustment Strap
to remove slack
roll up tightly so
the webbing is thick
enough to be held in
the storage band.
REMOVINg BABy FROM RESTRAINT
A. Press Upper Anchorage Strap Adjuster button (1) while pulling
Upper Anchorage Straps (2) to slacken (as shown below).
Allow Upper Anchorage Straps (2) to fall to the sides for easy
access into restraint as shown right.
b. lift harness Adjustment lever, while pulling each Shoulder
harness Strap to slacken harness to the desired amount.
C. Press red button on harness buckle then both harness
tongues will be released. move each shoulder strap to baby's
side then pick up baby.
d. lift baby out of the seat.
TO REMOVE RESTRAINT FROM VEHICLE
A. disengage seat belt tongue from buckle and remove
from restraint.
b. release the stored strap and fully press Upper
Anchorage Strap Adjuster button (1) while pulling
Upper Anchorage Strap (2) to slacken as shown right.
C. disengage Attachment Clip from Anchor Fitting. the
child restraint is now disconnected.
hoW to USe
bAbY USe reArWArd FACINg
Fully press Adjuster button (1) while
pulling Upper Anchorage Strap (2)
to lengthen.
1
2
Storage
band
Attachment Clip
Car's Anchor
Fitting
Press to
disengage
25
Hide quick links:
Advertisement
Table of Contents
