Table of Contents
Advertisement
hoW to USe
toddler USe ForWArd FACINg
REMOVINg CHILD FROM RESTRAINT
A. Press red button on harness buckle then both harness tongues will be released. lift the shoulder straps
from the child's shoulders and remove the child from the car. the seat is ready for use next time although
harness adjustments will be needed from time to time.
TO REMOVE RESTRAINT FROM VEHICLE
A. disengage seat belt tongue from buckle and remove from
restraint.
b. release the stored strap and fully press Upper Anchorage
Strap Adjuster button (1) while pulling Upper Anchorage
Strap (2) to slacken as shown right. In some vehicles
loosening of the Upper Anchorage Strap may be difficult. If
so, try pushing the restraint against the vehicle seat back
or slightly lifting the restraint to release the tension.
C. disengage Attachment Clip from Anchor Fitting. the child
restraint is now disconnected.
40
Fully press Adjuster button (1) while
pulling Upper Anchorage Strap (2)
to lengthen.
1
2
Storage
band
Attachment Clip (hook)
Car's Anchor
Fitting
Press to
disengage
REgULAR CARE OF THIS RESTRAINT:
Please check the following items regularly to ensure the safety of your child:
A. Check the webbing for fraying.
b. Check that the buckle clicks and is not sluggish or sticky in operation.
C. ensure there are no cracks in moulding or the plastic moulding.
d. Check the harness adjuster is operating and is clamping the webbing.
e. If any part of the restraint is cracked or broken, seek repair immediately or replace the child restraint.
TO CLEAN HARNESS BUCKLE:
If sticky liquids such as baby formula, fruit juice, etc. get inside your
harness buckle, it may become sluggish. An indication of a sluggish
harness buckle is that you cannot hear a click when engaging the
harness tongues. to restore the harness buckle to good working order
it needs to be cleaned as follows:
A. From the underside of the restraint pull each crotch 3-bar slide then
turn 3-bar slide and push through each slot to remove the harness
buckle from the restraint.
b. Place the harness buckle under warm (max. 40 degrees Celsius)
running water as shown. let the water run through the mouth of the
buckle for five minutes.
C. engage and disengage the harness tongues and buckles several times
until a strong audible click is heard.
d. If you still cannot hear a strong audible click after engaging the
harness tongues & buckle, then repeat cleaning several times. If the
harness buckle cannot be returned to its original working condition
then contact Next generation Nursery Products.
e. refit the harness buckle to the restraint with the red button facing
out & feeding each 3-bar slide through appropriate slot.
CAre & mAINteNANCe
Cover
body
3- bar
slide
Click
41
Hide quick links:
Advertisement
Table of Contents
