Installation Of Car Anchor Fitting - Hipod JS7A/2010 Instructions For Installation & Use

INStAllAtIoN oF CAr ANChor FIttINg

extension Strap distance to be measured.
length 300mm (Use Safe-n-Sound part 0035)
length 600mm (Use Safe-n-Sound part 0036)
Available from all major child restraint retailers.
Adjustable Upper
Anchorage Strap
the shaded areas of this diagram illustrate the possible locations of the anchor fitting. Within each shaded
area is an anchor fitting showing the correct way to install the fitting. ensure the anchor fitting is aligned
as illustrated unless stated otherwise in the vehicle owner's handbook.
50
dIStANCe to meASUre to
Front of Vehicle
the ANChor PoINt
Anchorage Clip Cover
Correct engagement of attachment
clip to anchor fitting.
INStAllAtIoN oF CAr ANChor FIttINg
IF THE CAR IS FITTED wITH CHILD RESTRAINT ANCHORAgE
POINT
locate the anchorage point behind the rear seating position.
(consult the car owners handbook for the location of the anchorage
point). the anchorage point should be directly behind and central to
the restraint. remove thread plug from the parcel shelf/floor/roof,
etc. and install anchor bolt and fitting as shown in Fig.1.
CAUtIoN: do Not oVertIghteN ANChor bolt. oVertIghteNINg
mAY FrACtUre or breAk bolt. mAXImUm torQUe IS 20 N.m.
(14.75 ft.lb.)
Note: minimum of five full turns of anchor bolt is required before
tightening force is applied.
IF THE CAR IS NOT FITTED wITH CHILD RESTRAINT ANCHORAgE
POINTS
For Sedans only - drill 9mm diameter hole in the parcel shelf on
the centre line of the seating position as shown in Fig.3. before
drilling the hole, check the underside for accessibility. Install the
anchor bolt as shown in Fig.2.
For vehicles other than Sedans - In Australia, consult your
nearest child restraint fitting station or traffic authority for vehicle
inspection to find the best, correct position for the placement of
the anchorage point, and for the correct attachment bolt length
and use of spacers. In New Zealand, consult the agent for the
vehicle.
Note to Queensland purchasers: the installation of anchorage
points must be approved by authorised officers appointed by
Queensland transport. Authorised officers can be sourced from all
Queensland transport Customer Service and Queensland Ambulance
Service Centres.
UPPER ANCHORAgE FITTINg
Fig.1. Attachment bolt
lock washer
Anchor fitting
Spacer(s) if
Vehicle
required
trim
Vehicle metal
structure
Front of Vehicle
UPPER ANCHORAgE FITTINgS
FOR SEDANS ONLy
Fig.2.
Attachment
bolt
Anchor fitting
Spacer(s) if
Vehicle
required
trim
Vehicle metal
structure
reinforcing washer
(cone downwards)
lock washer
Secure nut
51