Configuring Channelized Ports - Alcatel-Lucent 7705 Interface Configuration Manual

Common Configuration Tasks
Use the config port info command to display port configuration information.
ALU-A>config>port# info
----------------------------------------------
----------------------------------------------
ALU-A>config>port#

Configuring Channelized Ports

Channelized ports are supported on the 16-port T1/E1 ASAP Adapter card. Ethernet ports
and OC3/STM1 ports cannot be channelized.
When configuring channelized ports, the port ID is specified in different ways depending on
the TDM type and level of channelization, as follows:
Verifying the Adapter Card Type
To ensure that you have a channel-capable adapter card, verify the adapter card you are
configuring by entering a show mda slot-id command.
In the following example, MDA 3 and MDA 4 show a channelized DS1 adapter card.
*A:7705:Dut-C# show mda
===============================================================================
MDA Summary
===============================================================================
Slot
-------------------------------------------------------------------------------
1
===============================================================================
*A:7705:Dut-C#
Page 56
description "Ethernet access port"
ethernet
mode access
encap-type dot1q
exit
no shutdown
N × DS0 in DS1port.channel-group, where channel-group is {1 to 24}
N × DS0 in E1port.channel-group, where channel-group is {1 to 32}
Mda Provisioned
Mda-type
1 a4-oc3
2 a4-oc3
3 a16-chds1
4 a16-chds1
5 a8-eth
6 a8-eth
7705 SAR OS Interface Configuration Guide
Equipped
Mda-type
a16-chds1
a16-chds1
a8-eth
a8-eth
Admin Operational
State State
up provisioned
up provisioned
up up
up up
up up
up up