SONET/SDH Path Commands
path
Syntax
[no] path [sonet-sdh-index]
Context
config>port>sonet-sdh
Description
This command defines the SONET/SDH path.
The no form of this command removes the specified SONET/SDH path.
Default
no index
Parameters
sonet-sdh-index — specifies the components making up the specified SONET/SDH path
crc
Syntax
crc
Context
config>port>sonet-sdh>path
Description
This command specifies a cyclic redundancy check on the SONET/SDH path.
Default
32
Parameters
32 — use 32 bit checksum for the associated port/channel
7705 SAR OS Interface Configuration Guide
On the 4-port OC3/STM1 Clear Channel Adapter card, sonet-sdh-index is optional; if used, the
value must be sts3.
Syntax:
sts1-x.x
32
{
}
(the default is 32 when the encap-type is set to ATM; this default cannot be changed)
7705 SAR Interfaces
Page 101