Configuring Atm Interface Parameters - Alcatel-Lucent 7705 Interface Configuration Manual

Common Configuration Tasks

Configuring ATM Interface Parameters

ATM interface parameters can be configured for SONET/SDH ports in access mode, TDM
ports or channels supporting ATM encapsulation, and for IMA multilink bundles.
ATM interface parameters allow users to configure characteristics of an ATM interface. The
7705 SAR supports configuration of the following ATM interface characteristics:
ATM Interface Commands
Use the following CLI syntax to configure ATM interface parameters for SONET/SDH
ports.
CLI Syntax: port {port-id}
Use the following CLI syntax to configure ATM interface parameters for TDM channels.
CLI Syntax: port {port-id}
Page 60
• cell-format — allows the user to select the ATM cell format to be used on a given
interface: UNI or NNI (NNI is not supported on SONET/SDH interfaces)
• min-vp-vpi — allows the user to set the minimum allowable virtual path identifier
(VPI) value that can be used on the ATM interface for a VPC
sonet-sdh
path [sonet-sdh-index]
tdm
ds1
e1
7705 SAR OS Interface Configuration Guide
atm
cell-format cell-format
min-vp-vpi value
channel-group 1
atm
cell-format cell-format
min-vp-vpi value
channel-group 1
atm
cell-format cell-format
min-vp-vpi value