Configuring Adapter Card Clock Mode; Configuring Adapter Card Fabric Port Counters - Alcatel-Lucent 7705 Interface Configuration Manual

Common Configuration Tasks
Use the config mda info command to display adapter card configuration information.
ALU-B>config>card>mda# info
----------------------------------------------
----------------------------------------------
ALU-B>config>card>mda#

Configuring Adapter Card Clock Mode

Clocking mode is defined at the adapter card level. In Release 2.0 of the 7705 SAR, only the
T1/E1 ASAP Adapter card supports configuration of clocking mode and the only supported
clocking mode is adaptive.
Use the following CLI syntax to configure clocking mode on an adapter card.
CLI Syntax: config>card>mda#

Configuring Adapter Card Fabric Port Counters

Use the following syntax to configure fabric port counters on an adapter card.
CLI Syntax: config>card>mda#
Page 52
mda-type a16-chds1
network
ingress
queue-policy default
exit
exit
exit
clock-mode adaptive
no shutdown
[no] fabric-stats-enabled
7705 SAR OS Interface Configuration Guide