Transport; Frost Protection; Interrupting Operation; Storing The Appliance - Kärcher ProHD 100 Original Instructions Manual

– A firm grip impedes blood circulation.
– Continuous operation is worse than an
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
rence of the symptoms (e.g. cold, numb fin-
gers) please consult a physician.
Operation
ProHD 200 must only be operated in a hor-
izontal position (power switch at the top).
The other appliance versions can be oper-
ated in the horizontal or upright position.
Note:
The appliance is equipped with a pressure
switch. The motor starts up only when the
lever of the pistol is pulled
 Set the appliance switch to "I".
 Unlock the trigger gun and pull the lever
of the gun.

Interrupting operation

 Release the lever of the trigger gun; the
device will switch off.
 Release again the lever of the trigger
gun; the device will switch on again.
Turn off the appliance
 Set the appliance switch to "0".
 Disconnect the mains plug from the
socket.
 Shut off water supply.
 Activate trigger gun until device is pres-
sure-less.
 Press the safety lever of the trigger gun
to secure the lever of the pistol against
being released accidentally.

Storing the Appliance

 Place the spray lance with the trigger
gun into the quiver for the spray lance
and snap it into place in the spray lance
holder.
 Wind the connection cable around the
cable holder.
 Fasten the plug with the mounted clip.
Appliances with push handle and
wheels:
 Slide in push handle.
 Wind up the high-pressure hose and
hang it over the hose storage.
16

Frost protection

ATTENTION
Frost will destroy the not completely water
drained device.
Store the appliance in a frost free area.
If you cannot store it in a frost-free place:
 Drain water.
 Pump in conventional frost protection
agents through the appliance.
Note:
Use normal glycol-based anti-freezing
agents for automobiles.
Observe handling instructions of the anti-
freeze agent manufacturer.
 Operate device for max. 1 minute until
the pump and conduits are empty.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
 Hold the appliance at the carrying han-
dle and the recessed grip for carrying it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Appliances with push handle and
wheels:
 For transport over longer distances, pull
out the push handle to the end position
and drag the appliance behind you
holding the push handle.
 In order to climb stairs, pull the appli-
ance up step by step. The skids protect
the casing from damage.
Appliances with carrying belt:
CAUTION
Risk of injury due to machine dropping.
Check the carrying belt for damage prior to
using it.
 Put the carrying belt over your shoulder
and carry the appliance.
Holder for surface cleaner
 Attach the connecting piece of the sur-
face cleaner to the holder on the high-
pressure cleaner.
 Unscrew union nut.
Note:
With the ProHD 200 the holder can only be
used for a nozzle with screw connection.
– 4
EN

Transport