HIKVISION DS-9600NI-ST Series Quick Operation Manual page 56

User Manual of DS-9600/8600/7700/7600NI-ST and DS-7700/7600NI-SP Series NVR
11
PREV Button
12 DIRECTION/ENTER
Buttons
13 PTZ Button
14 ESC Button
15 RESERVED
16 F1 Button
17 PTZControl Buttons
18 F2 Button
Troubleshooting Remote Control:
Make sure you have installed batteries properly in the remote control. And you have to aim the remote control
Note:
at the IR receiver in the front panel.
If there is no response after you press any button on the remote, follow the procedure below to troubleshoot.
Steps:
1. Go to Menu > Settings > General > More Settings by operating the front control panel or the mouse.
2. Check and remember NVR ID#. The default ID# is 255. This ID# is valid for all the IR remote controls.
3. Press the DEV button on the remote control.
4. Enter the NVR ID# you set in step 2.
5. Press the ENTER button on the remote.
If the Status indicator on the front panel turns blue, the remote control is operating properly. If the Status indicator
does not turn blue and there is still no response from the remote, please check the following:
1. Batteries are installed correctly and the polarities of the batteries are not reversed.
2. Batteries are fresh and not out of charge.
3. IR receiver is not obstructed.
If the remote still can't function properly, please change a remote and try again, or contact the device provider.
Same as the PREV/FOCUS- button on front panel.
Same as the DIRECTION/ENTER buttons on front panel.
Same as the PTZ/IRIS- button on front panel.
Same as the ESC button on front panel.
Reserved for future usage.
Same as the F1/LIGHT button on front panel.
Buttons to adjust the iris, focus and zoom of a PTZ camera.
Same as the F2/AUX button on front panel.
22