Configuring Email - HIKVISION DS-9600NI-ST Series Quick Operation Manual

User Manual of DS-9600/8600/7700/7600NI-ST and DS-7700/7600NI-SP Series NVR

9.2.9 Configuring Email

Purpose:
The system can be configured to send an Email notification to all designated users if an alarm event is detected, etc.,
an alarm or motion event is detected or the administrator password is changed.
Before configuring the Email settings, the NVR must be connected to a local area network (LAN) that maintains an
SMTP mail server. The network must also be connected to either an intranet or the Internet depending on the location
of the e-mail accounts to which you want to send notification.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Set the IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway and the Preferred DNS Server in the Network
Settings menu, as shown in Figure 9. 20.
3.
Click
4. Select the Email tab to enter the Email Settings interface.
5. Configure the following Email settings:
Enable Server Authentication (optional): Check the checkbox to enable the server authentication
feature.
User Name: The user account of sender's Email for SMTP server authentication.
Password: The password of sender's Email for SMTP server authentication.
Figure 9. 20 Network Settings Interface
to save the settings.
Figure 9. 21 Email Settings Interface
153