Using The Auto Take-Up Reel Unit; Media Loading - Epson SC-F9200 series User Manual

SC-F9200 Series User's Guide
E
Take up the cut media completely by operating
the Manual switch according to how the media is
rolled.
F
Remove the take-up roll.
"Removing the Take-up Roll" on page 41
U
G
To remove the media, reverse the steps you
followed to load it.
"Loading media" on page 26
U
Using the Auto Take-up
Reel Unit

Media Loading

The Auto Take-up Reel Unit automatically takes up
media as it is printed. This improves the efficiency of
unmanned operation.
The Auto Take-up Reel Unit for this printer can take up
media in either of the following directions.
Printed side in
Basic Operations
Printed side out
35
Taking-up with printed side in places the printed
surface on the inside of the roll. Printed side in is
recommended in most situations.
Taking-up with printed side out places the printed
surface on the outside of the roll.
Caution:
❏ Follow the instructions in the manual when
loading media or roll cores or removing media
from the take-up roll.
Dropping media, roll cores, or take-up rolls
could result in injury.
❏ Be sure that your hands or hair do not get
caught in the media feeding unit or auto
take-up reel unit while it is operating.
Failure to observe this precaution could result
in injury.
Points to remember for correct
take-up
Observe the following points for correct take-up of
media.
❏ We recommend using a take-up roll core with the
same width as the media. If a take-up roll core of a
different width is used, the take-up roll core may
bend, and the media will be taken up incorrectly.
❏ We recommend Printed side in for the take-up of
media. When take-up cannot be perfomed
correctly with Printed side out, take-up using
Printed side in.
❏ Media less than 36 inches may be taken up
incorrectly.