Epson SC-F9200 series User Manual page 36

SC-F9200 Series User's Guide
Attaching the roll core
A
Set the Auto switch to off.
B
After confirming that the media is loaded
correctly, keep the d button pressed until the
edge of the media reaches the roll core holder.
c
Important:
Always press the d button to feed the media as
far as the roll core holder. If the media is pulled
by hand, the media may twist during take-up.
Basic Operations
C
Loosen the roll core holder locking screws and
adjust the roll core holders so that the distance
between the two is wider than the media.
Center the roll supports between the roll holders.
c
Important:
If the left roll core handle shaft is not visible,
rotate the handle as shown in the illustration
below until it stops. The roll core can not be
properly loaded if the handle shaft is not
visible.
D
Align the right roll core holder with the right
edge of the media and tighten the locking screw.
36