Maintenance And Care - Flex XC 3401 VRG User Manual

Polisher XC 3401 VRG

Maintenance and care

t^okfkd>
Before carrying out any work on the
polisher, always pull out the mains plug.
Cleaning
– Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use.
– Regularly blow out the housing interior and
motor with dry compressed air.
Carbon brushes
The polisher features cut-off carbon brushes.
When the wear limit of the cut-off carbon
brushes is reached, the polisher switches off
automatically.
klqb>
rëÉ=çåäó=çêáÖáå~ä=é~êíë=ëìééäáÉÇ=Äó=íÜÉ=
ã~åìÑ~ÅíìêÉê=Ñçê=êÉéä~ÅÉãÉåí=éìêéçëÉëK=
fÑ åçåJçêáÖáå~ä=é~êíë=~êÉ=ìëÉÇI=íÜÉ=Öì~ê~åíÉÉ=
çÄäáÖ~íáçåë=çÑ=íÜÉ=ã~åìÑ~ÅíìêÉê=ïáää=ÄÉ=ÇÉÉãÉÇ=
åìää=~åÇ=îçáÇK
When the polisher is being used, the carbon
brushes can be seen sparking through the rear
air inlet apertures.
If the carbon brushes spark excessively,
switch off the polisher immediately.
Take the polisher to a customer service
workshop authorised by the manufacturer.
Gears
klqb>
aç=åçí=äççëÉå=íÜÉ=ëÅêÉïë=çå=íÜÉ=ÖÉ~ê=ÜÉ~Ç EQF=
ÇìêáåÖ=íÜÉ=ï~êê~åíó=éÉêáçÇK=
kçåJÅçãéäá~åÅÉ=ïáää=ÇÉÉã=íÜÉ=Öì~ê~åíÉÉ=
çÄäáÖ~íáçåë=çÑ=íÜÉ=ã~åìÑ~ÅíìêÉê=åìää=~åÇ=îçáÇK
Replacing a worn Velcro pad
1. Pull out the mains plug.
2. Remove polishing sponge.
3. Place machine on its back.
4. Press spindle lock and loosen and
remove the screw with an Allen key.
Remove Velcro pad.
5. If required, clean the key surface of the
output shaft.
6. Place a new Velcro pad on the output
shaft.
The groove of the Velcro pad must mesh
with the key surface of the output shaft,
if required rotate the output shaft.
7. Screw in the screw and tighten with the
Allen key. Simultaneously press the spindle
lock.
8. Conduct a test run. Check for imbalances
and vibrations.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
klqb>
Only the tools released by FLEX may be used.
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
19