Flex XC 3401 VRG User Manual page 18

Preselecting the speed
– To set the operating speed, move the dial
(9) to the required value.
– Gently press the switch (7) to accelerate the
power tool up to the preselected speed.
klqb
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.
Attach or change tools
1. Pull out the mains plug.
2. Firmly press polishing material, centred on
the eye, onto the Velcro pad (11).
Use undamaged polishing tools only.
3. Insert the mains plug into the socket.
4. Switch on the polisher (without engaging it)
and run the polisher for approx.
30 seconds. Check for imbalances and
vibrations.
5. Switch off the polisher.
18
Operating instructions
`^rqflk>=
tÜÉå=íÜÉ=éçäáëÜÉê=áë=ëïáíÅÜÉÇ=çÑÑI=
íÜÉ éçäáëÜáåÖ=íççä=ÅçåíáåìÉë=êìååáåÖ=ÄêáÉÑäóK
klqb
Following a tool change (e.g. wool pad instead
of polishing sponge), the difference in weight
may increase the vibrations.
Change the operating speed with the
adjusting wheel (9) until the vibrations have
been reduced.
– Switch on the machine before placing it on
the surface which is to be polished and run
the polisher up to the set speed.
– Applying light contact pressure, move the
polisher in circular, overlapping movements
on the surface which is to be polished in
order to obtain a good polishing finish and
to ensure that the tool has a long service
life.
– On sensitive surfaces (e.g. car paintwork)
do not work aggressively but work at slow
speeds applying low contact pressure.
For further information on the manufacturer's
products go to www.flex-tools.de.
Polisher XC 3401 VRG