Spare Parts; Replacing The Bulb - Gram KF Type I Instructions For Use Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 30
GB
on and that the plug has been properly
inserted into the wall socket.
Unfamiliar sounds
Can be caused by tubes in the appliance
contacting each other or the outer clad-
ding.
- Check to make sure the refrigerator/
freezer is standing level.
Liquid noise
Caused by circulating refrigerant. This is
quite normal, even when the compressor
is not running.
Note also
The compressor starting system often
needs a pause before it can be restarted.
The compressor will itself automatically
decide how long the pause is to be.
Blocked defrost water drain
If blockage occurs, the most likely place is
the plastic bend at the outlet inside the
cabinet. Carefully remove the blockage,
then for safety's sake clean the bend with
a pipe cleaner or similar.
If the problem persists, the blockage might
be at the tube outlet into the defrost water
tray. The tray is located above the com-
pressor at the rear of the cabinet.

Spare parts

When ordering spare parts, please give
the refrigerator/freezer type and number.
This information is given on the nameplate
3
inside the cabinet.

Replacing the bulb

7
Turn the lock
14
remove the screen
change the bulb.
In some models, a gentle push will remove
4
the screen - see
Use a 15 Watt, 240 Volt bulb with a minia-
ture base.
34
a quarter turn and
to gain access and
15
.
15
Disposal
When disposing of an appliance for which
there is no longer any use, please do so in
an environmentally correct way. There mig-
ht be special requirements/conditions to be
observed.
You can obtain information on the disposal
of refrigeration appliances from:
- GRAM Domestic A/S
- Your white-goods supplier
- Authorities (the local council, Ministry of
the Environment, etc.)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KF Type I and is the answer not in the manual?

Table of Contents