Tuning Procedure When Rf Connections Are Used - Nokia Mediamaster 9820 T Owner's Manual

Tuning Procedure when RF Connections are Used

This procedure is necessary only if your Mediamaster is con-
nected to the TV with an RF lead and no SCART leads are
used
To tune your TV to the RF signal you might also need your TV
manual in addition to this manual. The steps below explain what
to do if you have been unable to use SCART leads in your con-
nection.
• Plug in your Mediamaster.
Tuning your TV to the Mediamaster
• Select a channel number on the TV that is not currently used
for other TV channels.
• Follow the instructions in your TV manual to tune the TV chan-
nel selector to UHF channel 43 (this is the Mediamaster's fac-
tory preset UHF channel). If you are already using this chan-
nel, select another non occupied UHF channel between 21to
69 on the TV.
• If you need to change UHF channel you do as follows:
First you change on the Mediamaster. Use the
on the front panel of the Mediamaster, or on the remote. You
will see the UHF channel number displayed on the front panel
of the Mediamaster. Then you tune the TV channel selector to
the same UHF channel.
• When you have correctly changed the UHF channel number
you will see the " Welcome " menu on the TV screen.
If there is interference from other channels you will have to
change the chosen UHF channel.
• Follow the instructions in your TV manual to store this UHF chan-
nel as the channel used by your Mediamaster. You will have to
select it when you want to watch terrestrial digital TV channels.
• Once the welcome message is visible, press the OK button
on the Mediamasters remote control to start the installation
procedure.
If for some reason you have to change the RF channel later,
you can do this by using TV settings menu further on in this
manual.
If you have a VCR connected it must be tuned to a different
UHF channel (between 21 to 69) than the Mediamaster.
You may now proceed to "First Time Installation."
GB 12
or buttons