Table of Contents
Advertisement
PROBLEM SOLVING
Problem
You made a video recording of a
digital terrestrial channel and whole
or parts of the programme was not
recorded.
The remote control is not working.
You see the on-screen message.
Viewing card faulty.
You have forgotten your secret PIN
code.
CA Module is not working.
Please note! The first thing to do before sending the Media-master to service is to:
1: Perform "Diagnostic" procedure in System Information menu.
2: Try downloading new software into the Mediamaster. With this procedure, the new software may solve the
problem in the quickest and most efficient way. See the relevant section "Receiver Upgrade" further on in this
manual.
What to do if you can't solve the problem
If you have tried all of the actions suggested above, without solving the problem, please
contact your dealer or Service Provider.
FRONT PANEL DISPLAY
When power-up, boot version,
product family and system soft-
ware version is shown.
When starting from standby, prod-
uct variant and system software ver-
sion is shown.
Remaining time in percent during
the download procedure.
The Mediamaster is in standby
mode, and current time is shown.
Channel number in TV
mode.
RF channel in tuning mode.
Possible causes
The Mediamaster was not left on
the appropriate channel.
The system is connected by SCART
leads and the VCR is not in AV/EXT
mode.
The system is connected by RF
leads and the VCR is not set to the
channel tuned for digital terrestrial
TV.
Battery exhausted.
Remote control is incorrectly
aimed.
The Mediamaster is in standby
mode.
The Mediamaster can't recognise
your smartcard.
CA module is not installed.
CA module is not correctly inserted.
What to do
If you make a recording of digital
terrestrial TV your Mediamaster has to
be left on the channel you like to record.
If the system is connected by SCART
leads, switch the VCR to appropriate AV
input.
If the system is connected by RF leads,
switch the VCR to the channel for digital
terrestrial TV. If you have not manually
tuned in the VCR you may do this first.
Please look in the VCR manaul for
instructions.
Change the batteries (both.
Aim the remote control at box.
Check that nothing blocks the front
panel.
Check if (.) is flashing on the front panel
display when you press a button. If not
replace the batteries (both).
Check that you are using the proper
Smartcard. Check that the Smartcard
has been correctly inserted. If the
problem persists, you may have a
problem with the card.
Contact your dealer or Service Provider.
Contact your Service Provider. They will
help you set it up again.
Check that the CA module has been
correctly inserted.
Contact your dealer or Service Provider.
In TV mode.
.
In video mode
When downloading new software
.
via the air
When downloading new software
via the Serial RS232 socket
Error messages. For service per-
sonnel
Lights when no signal is being re-
ceived. Flashes when pressing a
button on the remote control.
.
GB 31
Advertisement
Table of Contents
