Configuring Ppg User Group Variables - Kannel WAP and SMS gateway User Manual

Variable
ssl-server-key-file
ppg-url
global-sender
concurrent-pushes
users
trusted-pi
ppg-deny-ip
ppg-allow-ip
default-smsc
Configuring PPG user group variables
In addition of pi lists similar to the core group, ppg configuration spesific to a certain user contains
variables used for authentication and enforcing restrictions to phone numbers pi may contact. All
Value
string
url
string
number
number
boolean
ip-list
ip-list
string
Chapter 7. Setting up Push Proxy Gateway
Description
Mandatory value for PPG
HTTPS support. The file
containing server's ssl private
key.
URL locating PPG services.
Default
/wappush
Sender phone number required
by some protocols.
Number of concurrent pushes
expected. Note that PPG does
work even value is too low; it
will only be slower. Default 100.
Number of actually configured
user accounts. Note that PPG
does work even value is too low;
it will only be slower. Default
1024.
If true, PI does authentication
for PPG. Obviously, both of them
must reside inside same firewall.
Default true. If this variable is
true, all security variables are
ignored (even though they may
be present).
PPG will not accept pushes from
these IPs. Wildcards are allowed.
If this attribute is missing, no IP
is denied by this list .
PPG will accept pushes from
these, and only these, IPs.
Wildcards are allowed. Adding
this list means that IPs not
mentioned are denied, too.
If no SMSC ID is given with the
wappush HTTP request (see
below), use this one as default
route for all push messages.
.
85