Sema Group Sms2000 Ois 4.0 And 5.0 - Kannel WAP and SMS gateway User Manual

Variable
msg-id-type
alt-charset

Sema Group SMS2000 OIS 4.0 and 5.0

The 4.0 implementation is over Radio PAD (X.28). Following configuration variables are needed, and if
Value
number
string
Chapter 5. Setting up a SMS Gateway
Description
Optional, specifies which
number base the SMSC is using
for the message ID numbers in
the corresponding
and
submit_sm_resp
PDUs. This is
deliver_sm
required to make delivery reports
(DLR) work on SMSC that
behave differently. The number
is a combined set of bit 1 and bit
2 that indicate as follows: bit 1:
type for
submit_sm_resp
2: type for
deliver_sm
bit is set then the value is in hex
otherwise in decimal number
base. Which means the following
combinations are possible and
valid: 0x00
deliver_sm
decimal,
submit_sm_resp
decimal; 0x01
deliver_sm
decimal,
submit_sm_resp
0x02 hex,
deliver_sm
decimal;
submit_sm_resp
0x03 hex,
deliver_sm
hex. In
submit_sm_resp
accordance to the SMPP v3.4
specs the default will be a C
string literal if no of the above
values is explicitly indicated
using the config directive.
Defines which character
encoding is used for this specific
smsc link. Uses
iconv()
routines to convert from and to
that specific character set
encoding. See your local
iconv_open(3) manual page for
the supported character
encodings and the type strings
that should be presented for this
directive.
, bit
. If the
hex;
41