Sendsms-User Configurations; Sendsms-User Group Variables - Kannel WAP and SMS gateway User Manual

SendSMS-user configurations
To enable an SMS push, you must set
'sendsms-user' groups. Each of these groups define one account, which can be used for the SMS push,
via HTTP interface (see below)
Table 5-10. SendSMS-User Group Variables
Variable
group (m)
username (m)
password (m)
name
user-deny-ip
user-allow-IP
forced-smsc
default-smsc
default-sender
faked-sender
max-messages
concatenation
split-chars
split-suffix
omit-empty
header
footer
into the 'smsbox' group and define one or more
sendsms-port
Value
sendsms-user
string
string
string
IP-list
IP-list
string
string
phone-number
phone-number
number
bool
string
string
bool
string
string
Chapter 5. Setting up a SMS Gateway
Description
This is a mandatory variable
Name for the user/account.
Password for the user (see
HTTP interface, below)
As in 'sms-service' groups.
As other deny/allow IP lists, but
for this user (i.e. this user is not
allowed to do the SMS push
HTTP request from other IPs
than allowed ones). If not set,
there is no limitations.
Force SMSC ID as a 'string'
(linked to SMS routing, see
'smsc' groups)
If no SMSC ID is given with the
send-sms request (see below),
use this one. No idea to use with
forced-smsc.
This number is set as sender if
not set by get/post
from
parameter
As in 'sms-service' groups
67