2.6 Setting the RDC Password
The procedure to set the security password necessary to perform the RDC communication is described
in this section.
<<Operation procedure>>
(1) Turn ON the power while [1] and [3] are pressed simultaneously to enter the function mode. Set the
value for the code "957" to "1".
(2) Turn OFF the power and back ON.
(3) Register a RDC password.
a. Press the [SETTINGS] icon to enter the
setting/registration menu.
Press the [NEXT] icon and then [RDC
PASSWORD] icon.
b. Press the [PASSWORD] icon, and enter a
password to be registered in the number
entry screen.
(4) Turn OFF the power, then back ON while "1" and "3" are pressed simultaneously to enter the function
mode (13) again.
(5) Set the value for the code "957" to "0" , then turn OFF the power.
* The security function becomes effective when the value for 13-956 is set to "1".
October 2000 © TOSHIBA TEC
2 - 33
GD1080/1090 SELF-DIAGNOSIS MODE