Table of Contents
Advertisement
b. State of the machine
Availability of the recording paper:
st
1
cassette (size =
nd
2
cassette (size =
3
rd
cassette (size =
th
4
cassette (size =
c. Conditions of RADF (this information is needed for transmission error)
Originals have been all discharged
Abnomal (original jam, etc.)
Others (be as specific as possible): _______________________________ )
d. Condition/state of the communication
Transmission error
Reception error
ECM mode
G3 mode
Image errors such as stream image or interrupted image occur in the G3 mode when the noise
occurs on the line. These are liable to occur since the line condition differs depending on each
communication.
If the same errors occur to the image which was resent, they can be decreased by reducing the
transmission speed of the sending side.
Communication cannot be made with a particular number.
(Information of the other side's machine:
If the communication is impossible with a particular number, it is considered that the other party's
machine has broken down or has been busy (there is no response) because the recording papers
have run out and the memory is full. Check the condition of the terminal of the other side.
If there is no problem with the terminal, check the model name since there is a possibility that
that particular type of the machine has caused the problem.
Original size =
Size of the received document =
Resolution =
Error occurred to the __________ st/nd/rd/th sheet out of ___________ sheets.
GD1080/1090 TROUBLESHOOTING
)
No paper
)
No paper
)
Not installed
)
Not installed
A3
A3
NORMAL (8*3.85)
Paper present
Paper present
No paper
No paper
B4
A4
B5
B4
A4
B5
FINE (8*7.7)
3 - 12
Paper present
LCF
Paper present
LCF
)
A5
A5
U-FINE (16 or 8*15.4)
October 2000 © TOSHIBA TEC
Advertisement
Table of Contents
