Toshiba GD 1080 Service Handbook page 7

[A] Error code list
If an error has occurred during communication, an error code is indicated below "STATUS" on the
transmission/reception journal.
Take the appropriate action referring to the following list.
Error code Content
00 Normal
11 Paper jam
12 Original jam
13 Door is open
20 Power failure
30 (Reset)
33 Polling error
42 Memory full
50 Line is busy
53 Security mismatch
in relay or mail box
transmission
B0 Initial signal not
detected
B1 Terminal constants
not compatible
B2 Reception of DCN
(Phase B)
B3 DCS/DTC not detected
B4 Training error
B5 CFR not detected
C0 Image signal
carrier not detected
C1 High speed signal
not detected
C2 Image signal carrier
disconnected
C3 1st EOL not detected
C4 EOL not detected
D0 Post message not
detected
D1 Reception of DCN
D2 Poor image quality
E0 Image memory error
GD1080/1090 ERROR CODES
Situation and corrective action
Remove the jamming paper.
Remove the jamming document and retransmit it.
Close the doors securely and retransmit the document.
A power failure occurred during transmission or reception, and the transmis-
sion/reception data were lost. Attempt the transmission/reception again.
Communication was stopped by the FC key.
Polling was not performed because the polling document was not found. Check
the polling document on the other side and attempt the polling again.
The memory became full during reception. (The pages normally received are
printed out.) Check the remaining memory space and attempt the reception again.
Transmission is not made because the line is busy. Attempt the transmission
again. As the number of the redialings are increased, the possibility for success-
ful transmission is increased.
Check your security code and system password of the other side as well as your
own.
NSF/DIS cannot be detected. Check the receiver and attempt the transmission
again.
DIS/NSF that cannot be handled by the sender was received. The receiver re-
ceived NSS/DCS other than those declared by DIS/NSF. Check the transmis-
sion/reception functions, and attempt the communication again.
DCN was received in the phase B.
DCS/DTC cannot be detected.
The sender performed fall-back but the transmission was not made. After the
reception of FTT, the receiver received a time-out or DCN. Adjust the transmitter
attenuator, link equalizer, etc. and retry the communication.
A training signal was sent out but CFR cannot be detected. Adjust the transmitter
attenuator, link equalizer, etc. and retry the transmission.
A carrier was not detected on the receiving side. Adjust the transmitter attenuator,
link equalizer, etc. and retry the transmission.
High-speed signals were not detected on the receiving side. Adjust the transmit-
ter attenuator, link equalizer, etc. and retry the transmission.
Carrier disconnection was detected after the image signal was detected.
1st EOL was not detected after the high-speed signal was detected.
EOL cannot be detected on the receiving side. Or decoding is not possible with MMR.
A post message cannot be detected. Retry the communication. MCF, RTP , RTN,
PIN and PIP cannot be detected on the sending side. MPS, EOM and EOP can-
not be detected on the receiving side.
DCN was received.
Quality of the received image is poor. Retry the transmission.
Hardware is defective.
1 - 2 October 2000 © TOSHIBA TEC