Cab-1 Numeric Keypad Commands For Your Sd 60/70 - Lionel SD 60 Owner's Manual

TrainMaster Command operations

CAB-1 numeric keypad commands for your SD 60/70

W
hen you press AUX1 on
CAB-1, you turn the
numeric keypad into 10 com-
mand buttons. The keypad lets
you control extra command fea-
tures (until you press any top-
0 Stops and resets the SD 60/70's.
Resets the SD 60/70's direction to FOR-
WARD. Resets Railsounds to automatic
RPM operation. Horn blows. RPMs
return to automatic.
1 Raises the volume of Railsounds.
Sound volume increases.
2 CrewTalk™ is the .sound of inaudible
walkie-talkie communication.
3 Raises Railsounds RPM level.
Starts up Railsounds. RPMs
increase. Startup sequence
commences.
4
Lowers the volume of Railsounds.
Sound volume decreases.
5
Activates the Railsounds shutdown
sequence. Just like the real thing, your
SD 60/70's RPMs must be at idle for
shutdown to occur. Press 6 repeatedly
to lower RPMs until they won't descend
further. Your locomotive is now at idle.
Press 5 to initiate the shutdown
Note!
AUX1-9 only works if the smoke unit switch is in the on position.
AUX1
row button like SW, ACC, RTE,
TR, or ENG).Railsounds
sounds in bold italic.
(Upgrade required for
these).
sequence, following Crewtalk sound.
Crewtalk sounds, Diesel shut-
down commences. Remember, the
horn, bell, and RPMs will not sound
until you restart Railsounds.
6
Lowers Railsounds RPM level.
RPMs decrease.
7
TowerCom™ is an audible announce-
ment that includes that engine's road
number and/or name. There is a Four
second delay in this function.
8
Smoke off
Crewtalk sounds
9
Turns on the smoke generator. Press
and hold 9 (10 seconds maximum) to
initiate Smoke Boost™ — it super-
heats the smoke generator and
enhances smoke output when you start
running your steam locomotive. See
notes on filling or turning off the
smoke generator on page 8.
Crewtalk sounds
19