Lionel SD 60 Owner's Manual page 22

Reprogramming R2LC circuit boards to restore features
D ue to the inevitable derailments, static,
and the negative nature of electricity,
it is possible that your R2LC could someday
lose its setup program.The symptoms of this
STEP 1: Move switch on locomotive from
run to program.
STEP 2: Turn on Command Base.
STEP 3: Place locomotive on track, then
turn on power to track.
STEP 4: Press "ENG" then input locomo-
tive's ID#. Press "SET"
STEP 5: Press "ENG", then the ID#,
"AUX1", then press 8 for your locomotive.
Note!
To program your R2LC as a diesel locomotive with
smoke, follow these steps. (These steps will also
restore programming which is accidentally lost due
to static, numerous derailments, etc.)
condition would be unresponsiveness in
command mode. This can be easily reme-
died by "reprogramming" your R2LC using
the following steps.
STEP 6: Turn off power to track, wait ten
seconds.
STEP 7: Remove locomotive from track,
move switch from program to run.
STEP 8: Place locomotive back on track,
turn power on to track.
STEP 9: Press "ENG" and ID#, then oper-
ate as normal.
22