Assigning Your Sd 60/70 A New Id - Lionel SD 60 Owner's Manual

TrainMaster Command operations

Assigning your SD 60/70 a new ID#

Assign a new I D# to your
Example
Command-equipped SD
60/70
Command Base ON
Place the SD 60/70 on track
PowerMasters set to CMD or
traditional power supplies ON FULL
Set the SD 60/70 reverse unit control
switch to PROGRAM
Turn track power on (PowerMasters):
Press BOOST
Program the SD 60/70 with a new
ID#:
Press ENG
Press a number you choose
(the ID#)
Press SET
Set the reverse unit control switch
to FORWARD/RUN
Your SD 60/70 set remembers its ID# for-
ever; change it any time with these
steps
A
s your fleet of Command-equipped
Lionels grows, you'll want to give your
SD 60/70 a more individualized number.
Choose from any between 1 and 99. To make
things easy, use a portion of your SD 60/70's
cab number.
Turn the Command Base ON and place
the SD 60/70 on track. Power up, then set
the SD 60/70's reverse unit control switch to
PGM (see the illustrationon page 5). Using
CAB-1, press ENG, the locomotive ID# (you
select: ?), then press the SET button located
under CAB-1's removable panel. Hear the
horn blow (or see the headlight flash if
Railsounds is off); that's the R2LC confirm-
ing the new ID#. Set the reverse unit control
switch to RUN. Your SD 60/70 is ready for
operations with its all-new ID#.
We recommend that you choose an easy to
remember ID# for your engine. Some possi-
bilities are part of the engine road number,
your age, any two digit number that is not
used by another engine. Write the number on
a small piece of tape and put this on the bot-
tom of the fuel tank to aid in remembering.
21