Command Control Upgrade
T
his upgrade is made using kit 6-22960,
which includes a radio circuit and an
antenna. Remove the cab from the chassis as
shown on page 7. First, unplug the 104E unit
circuit board and set it aside. This circuit
board is mounted closest to the smoke unit.
Pull straight back from its mounting pins to
104 E Unit
Rear of Engine
14
remove it. Next plug in the circuit board
(R2LC) into the slot marked "Radio". (same
slot as the 104E unit used)
Note: The antenna is not needed. One has
been provided with your locomotive
Command
Control Board
Front of Engine