Hyundai WS 1728 Instruction Manual page 28

Outdoor Thermo Sensor Unit Registration Procedure:
• The main unit automatically starts receiving transmission from Outdoor Thermo Sensor for
outdo or temperature after new batteries are inserted.
• The thermo sensor will automatically transmit temperature to the main unit after batteries
inserted. Batteries compartment of thermo sensor is locating behind the back cover, unscrews
to open. Press " TX " button on the thermo sensor unit to transmit temperature to the main
unit manually. The main unit gives a "beep" sound if it received the temperature.
• If the main unit cannot receive the temperature transmitted from the thermo sensor, hold
"SEARCH" button (D) for 3 seconds to cancel the channel manually. It will automatically
register the thermo sensor again if a temperature signal is received. If there is no temperature
displayed in existing channel ( " - - . –" is displayed on the LCD ), hold "SEARCH" button (D)
for 3 seconds to cancel that channel and receive the channel again, a "Beep" sound can be
heard.
The use of 1.5m cord Temperature Probe:
• Insert the probe plug on the right hand side of the Thermo Sensor Unit.
• Put the metal casing outside and leave the Thermo Sensor Unit in a indoor area to avoid
freezing up the battery when the outdoor temperature is below 0 °C.
• Always use the temperature probe to sense the temperature when the temperature
is between the following range: -50 °C ~ 0°C and +50°C ~ + 70°C
Projection:
• Slide the Projection ON/OFF Slide Switch (F) to "On" to switch on the Projector.
• Press "SNOOZE/ PROJECTION/ LIGHT"(H) to project Time and Temperature
(Press "SNOOZE/ PROJECTION/ LIGHT(H)" to change projection content)
• Turn right or left of the "Focus" Wheel (I) to adjust appropriate focus.
• Slide Project "ROTOTE" Slide Switch (G)to reverse the projection content 180°.
12/24 Hr:
• Press " 12/24" button(C) to select 12 or 24 hours mode.
Back Light:
• Press "SNOOZE/ PROJECTION/ LIGHT" button (H), back light states for 5 seconds
Low batteries indicator:
• Low battery icon „ " appear at outdoor temperature row or thermo sensor unit indicates
the external transmitter is in low battery status and batteries should be replaced.
EN - 28