Class 1 Laser Product Label; Safety Instructions - Hyundai TRC 182 ADRU3BBL Instruction Manual

Mp3/cd/radio portable player
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 17
WARNING
1) WARNING: Please refer the information on exterior bottom enclosure for electrical and safety information before installing
or operating the apparatus.
2) WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or
3) WARNING: The battery (battery or batteries or battery pack) shall not be exposed to excessive heat such as sunshine, fire
or the like.
4) WARNING: The mains plug is used as disconnect device, the disconnect device shall remain readily operable.
5)
nvisible laser radiation when open and interlocks defeated.
Avoid exposure to beam of laser.
6)
Correct Disposal of this product. This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased. They can
take this product for environmental safe recycling.
7) No naked flame sources, such as lighted candles, should be placed on the apparatus.
8) Attention should be drawn to environmental aspects of battery disposal.
9) Use of the apparatus in moderate climates.
10) The rating and marking information are located at the bottom of the unit.
11) Excessive sound pressure from earphone and headphones can cause hearing loss.
12) The mains plug of unit should be obstructed or should be easily accessed during intended use.
13) To be completely disconnect the power input, the mains plug of apparatus shall be disconnected from the mains.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
WARNING
TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
The following label has been affixed to the unit, listing the proper procedure for working with the laser beam:
WARNING LABEL INFORMING OF RADIATION
This label is placed inside the unit. As shown in the illustration. To warn against further measures on the unit.
The equipment contains a laser radiating laser rays according to the limit of laser product of class 1.

SAFETY INSTRUCTIONS

1) READ INSTRUCTIONS – All the safety and operating instructions should be read before the appliance is operated.
2) RETAIN INSTRUCTIONS – The safety and operating instruction should be retained for future reference.
3) HEED WARNINGS – All warnings on the appliance and in the operating instructions should be adhered to.
4) FOLLOW INSTRUCTIONS – All operating instructions should be followed.
5) WATER AND MOISTURE – The appliance should not be used near water, for example, near a bathtub, washbowl, kitchen
sink, laundrytub, swimming pool or in a wet basement.
6) VENTILATION – The appliance should be situated so that its location or position does not
interfere with its proper ventilation. Do not place on bed, sofa, rug or similar surface that may block the ventilation openings,
in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.
7) HEAT – The appliance should be situated away from heat sources such as radiators, stoves, or other appliances (including
amplifiers) that produce heat.
8) POWER SOURCE – The appliance should be connected to power supply only of the type described in the operating
instructions or as marked on the appliance.
9) POWER CORD PROTECTION – Power supply cords should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them.
10) POWER LINES – An outdoor antenna should be located away from power lines.
11) OBJECT and LIQUID ENTRY – Care should be taken so that objects do not fall and liquids are not spilled into
the enclosure through openings.
12) ESD WARNING – The display does not function properly or no reaction to operation of any the control may due to
the electrostatic discharge. Switch off and unplug the set. Reconnect after a few seconds.

CLASS 1 LASER PRODUCT LABEL

This label is attached to the place as illustrated to inform that the apparatus contains a laser
component.
EN - 17
LIGHTNING FLASH WITH ARROWHEAD SYMBOL – within an
equilateral triangle, is intended to alert the user to the presence of
uninsulated dangerous voltage within the products enclosure that
may be of sufficient magnitude to constitude a risk of electric
shock to persons.
EXCLAMATION POINT – within an equilateral triangle, is used
to indicate that a specific component shall be replaced only by
the component specified in that documentation for safety reason.
EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Trc 182 adru3sbTrc 182 adru3br

Table of Contents