Wlan Module - HP 17-P series Maintenance And Service Manual

WLAN module

Description
Realtek RTL8188EE 802.11b/g/n 1x1 Wi-Fi Adapter
Realtek RTL8723BE 802.11b/g/n 1x1 Wi-Fi + BT4.0 Combo Adapter
CAUTION:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the base enclosure and top cover (see
Remove the WLAN module:
1. Disconnect the #1 and #2 WLAN antenna cables from the WLAN module (1) if you have not already done
so to remove the display panel.
NOTE:
NOTE:
antenna cable is connected to the WLAN module #2 auxiliary terminal.
2. Remove the Phillips PM screw(s) (2) that secure the WLAN module to the system board. (The WLAN
module tilts up.)
42 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To prevent an unresponsive system, replace the wireless module only with a wireless module
Battery on page
Optical drive on page
The WLAN module may have two screws depending on the model.
The #1 WLAN antenna cable is connected to the WLAN module #1 main terminal. The #2 WLAN
26).
27).
Base enclosure on page
Spare part number
709848-005
753077-005
30).