Rtc Battery; Remove The Wlan Module (See Wlan Module; Remove The System Board - HP 17-P series Maintenance And Service Manual

7. Remove the WLAN module (see
8. Remove the system board (see
Remove the memory module:
1. Turn the system board over.
2. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module.
(The memory module tilts up.)
CAUTION:
components on the memory module.
3. Slide the memory module forward (2) to remove it.
Reverse this procedure to install a memory module.

RTC battery

Description
RTC battery
Before removing the RTC battery, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
WLAN module on page
System board on page
To prevent damage to the memory module, hold it by the edges only. Do not touch the
Battery on page
Optical drive on page
42).
50).
26),
27).
Component replacement procedures
Spare part number
697917-001
55