Table of Contents
Advertisement
3. Check air gap between magneto ring and trigger coil.
The gap should be 0.6 to 0.9 mm 1.023" to .035").
O
NOTE: It is recommended to use a brass feeler
gage.
4. Check timing using a stroboscopic timing light (on
each cylinder).
•
WARNING: Place ski tips against the wall, raise
rear of vehicle so the track is not in contact with
the ground andptace it on a stand equipped with a
protector. Make sure nobody passes behind the vehi-
cle during timing procedure.
Magneto ring mark and crankcase central mark
should align at 5000 R.P.M.
Magneto
ring mark
If necessary to adjust: unscrew slightly the two (2)
screws holding trigger coil bracket, then move brack-
et up or down.
If correct timing is impossible with trigger coil brack-
et travel, stop engine, remove bracket from crank-
case and relocate the trigger coil on its bracket.
...
...
Vehicle General Inspection
Check electrical wiring and components, retighten loose
connections. Check for stripped wires or damaged insu-
lation. Thoroughly inspect the vehicle and tighten loose
bolts, nuts and linkage. Inspect skis and ski runners for
wear.
Tail Light Bulb
The taillight bulb must always be on when the engine is
running. If the taillight bulb is burnt, expose bulb by
removing red plastic lens.
25
Advertisement
Table of Contents
